My SBCs that I have installed Lazarus IDE on them.
2022.10.17 14:45
Following is my SBC (Single Board Computer) list that I have successfully installed Lazarus IDE.
1. Raspberry Pi 3B (Needed to set 2G Virtual RAM)
2. Raspberry Pi 4B
3. Orange Pi Zero 512M (Needed to set 2G Virtual RAM)
4. Orange Pi One (Needed to set 2G Virtual RAM)
5. Orange Pi Lite 2 (Needed to set 2G Virtual RAM)
6. Orange Pi 2 (Needed to set 2G Virtual RAM)
7. Orange Pi 3 LTS
8. Orange Pi 4 LTS
9. Atomic Board
10. VIM3
11. Odroid H2+ <= This one is intel celeron based, and became my main PC now.
12. Orange Pi 5 w/ 8G RAM & 6 TOPS NPU (2 TOPS NPU x 3)
13. Orange Pi Zero 3, 4G RAM
It is all installed with fpcupdeluxe. Make sure to install with fpcupdeluxe.
Do not waste your time with "sudo apt-get install fpc lazarus" method, cause it looks like it works, yet causes problem over and over again.
Comment 0
No. | Subject | Author | Date | Views |
---|---|---|---|---|
12 |
Project Moomalengi 무말랭이 (Seasoned Dried Radish)
![]() | me | 2025.01.19 | 36 |
11 |
Circuit Python 실험.
[1] ![]() | me | 2023.09.25 | 203 |
10 |
Speedybee F405 WING
![]() | me | 2023.09.05 | 245 |
9 |
Orange Pi Zero 3 with Debian
![]() | me | 2023.09.02 | 235 |
8 |
Logitech G Extreme 3D Pro USB Joystick
![]() | me | 2023.08.26 | 249 |
7 | Beagle Bone Blue as flight controller | me | 2023.08.26 | 311 |
6 | Ardupilot (Ardu-Rover) with Lidar | me | 2023.08.10 | 235 |
5 |
2D Lidar enabled Rover Tutorial Project
[1] ![]() | me | 2023.07.17 | 225 |
4 |
Beagle Bone Blue for ArduPilot (Rover, Plane, Drone, Submersible, etc)
![]() | me | 2023.07.11 | 254 |
3 | Souther California R/C Flying Clubs | me | 2023.07.05 | 196 |
2 |
Project : Rover One
![]() | me | 2023.01.18 | 273 |
» | My SBCs that I have installed Lazarus IDE on them. | me | 2022.10.17 | 249 |